Grill Out

Classic Baby Back Ribs

• Rub
  • 2tablespoons kosher salt
  • 2tablespoons paprika
  • 4teaspoons granulated garlic
  • 4teaspoons pure chile powder
  • 2teaspoons ground black pepper
  • 1teaspoon ground cumin
•  
  • 4racks baby back ribs, each 2 to 2-1/2 pounds
  • 4medium chunks of hickory wood, soaked in water for at least 30 minutes
• Barbecue sauce
  • 3/4cup apple juice
  • 1/2cup ketchup
  • 3tablespoons cider vinegar
  • 2teaspoons soy sauce
  • 1teaspoon Worcestershire sauce
  • 1teaspoon molasses
  • 1/2teaspoon pure chile powder
  • 1/2teaspoon granulated garlic
  • 1/4teaspoon ground black pepper
• Mop
  • 1cup apple juice
  • 3tablespoons cider vinegar
  • 2tablespoons unsalted butter
  • 2tablespoons barbecue sauce (from above)

1. In a small bowl mix the rub ingredients.

2. Using a dull knife, slide the tip under the membrane covering the back of each rack of ribs. Lift and loosen the membrane until it breaks, then grab a corner of it with a paper towel and pull it off. Season the ribs all over, putting more of the rub on the meaty sides than the bone sides. Arrange the ribs in a rib rack, with all the ribs facing the same direction. Allow the ribs to stand at room temperature for about 30 minutes, or until the surface looks moist, before grilling.

3. Fill a chimney starter to the rim with charcoal and burn the charcoal until it is lightly covered with ash. Spread the charcoal in a tightly packed, single layer across one-third of the charcoal grate. Place a large disposable drip pan on the empty side of the charcoal grate. Fill the pan about halfway with warm water. Let the coals burn down to low heat (250° to 300°F). Leave all the vents open.

4. When the fire has burned down to low heat, drain 2 hickory chunks and place them on top of the charcoal. Put the cooking grate in place. Place the rib rack over indirect low heat (over the drip pan) as far from the coals as possible, with bone sides facing toward the charcoal. Close the lid. Close the top vent about halfway. Let the ribs cook and smoke for 1 hour. During that time, maintain the temperature between 250° to 300°F by opening and closing the top vents. Meanwhile, make the sauce and the mop.

5. In a small saucepan mix the barbecue sauce ingredients. Simmer for a few minutes over medium heat, and then remove the saucepan from the heat.

6. In another small saucepan mix the mop ingredients. Simmer for a few minutes over medium heat to melt the butter, and then remove the saucepan from the heat.

7. After the first hour of cooking, add 8 to 10 unlit charcoal briquettes and the remaining 2 hickory chunks (drained) to the fire. At the same time, lightly baste the ribs with some mop. Leaving the lid off for a few minutes while you baste the ribs will help the new briquettes to light. Close the lid and cook for another hour. During that time, maintain the temperature of the grill between 250° to 300°F by opening and closing the top vents.

8. After 2 hours of cooking, add 8 to 10 unlit charcoal briquettes to the fire. Remove the ribs from the rib rack, spread them out on clean work area and baste them thoroughly with some mop. Put them back in the rib rack, again all facing the same direction, but this time turned over so that the ends facing down earlier now face up. Also position any ribs that appear to be cooking faster than others toward the back of the rib rack, farther from the charcoal. Let the ribs cook for a third hour. During that time, maintain the temperature between 250° to 300°F by opening and closing the top vents.

9. After 3 hours of cooking, check if any rack is ready to come off the grill. They are done when the meat has shrunk back from most of the bones by 1/4 inch or more. When you lift a rack by picking up one end with tongs, the rack should bend in the middle and the meat should tear easily. If the meat does not tear easily, continue to cook the ribs. The total cooking time could be anywhere between 3 to 4 hours. Not all racks will cook in same amount of time. Lightly brush the cooked ribs with some sauce and, if desired for crispiness, cook them over direct heat for a few minutes. Transfer to a sheet pan and tightly cover with aluminum foil. Let rest for 10 to 15 minutes before serving. Serve warm with the remaining sauce on the side.

• Currently Rated 5/5

Average Rating

Mark as favorite

Discuss (1 comments)

User Comments

May 30, 2011

12:30 PM

says...

So rib racks are a must for making "low and slow" baby backs. This recipe is easy to follow, although some of the techniques in the video don't exactly match the printed recipe, as in wood chips vs. chunks, also I'm not a fan of adding unlit charcoal every hour (I prefer lit charcoal). Also, I found that starting with the full chimney of briquettes caused the kettle temperature to be too hot, and it took a while to get the kettle down to 300. Other than that, the rub was super tasty, I got a great smoke flavor from the pork, and the bbq sauce was very good. For me, 3 Costco sized ribs took almost 4 hours to cook on a somewhat cold and windy day. Patience and attention to the cooking temps were a key to great ribs.

Leave a commentYou must login to post a comment

Success! Your comment has been submitted and is awaiting approval.

Error! Please enter a valid comment.