Weber® Flame iQ® to suit Baby Q (3rd Generation)

The Flame iQ is a flame safeguard system. It's a type of flame safeguard device, with added features and benefits.

A flame safeguard device is designed to stop the flow of gas to an appliance in the case that the gas flame goes out – for example, if the flame is blown out in windy conditions.

The Flame iQ flame safeguard system has the added functionality of continuously sensing for a flame. It will attempt to reignite the burner in the event of a ‘flame out’ (up to 3 attempts), before shutting off the gas and going into a lockout mode. If the burner reignites, the Flame iQ will reset for another 3 attempts.

The Flame iQ features a sensing probe, situated on the burner. If the probe senses a ‘flame out’, it sends a signal to the Flame iQ, which then attempts to reignite the burner, up to 3 times at 5 second intervals.

If the burner is not reignited by the third relighting attempt, it will shut off the gas to the burner and go into lockout mode. This is shown on the Flame iQ when the reset light is illuminated.

If the burner is successfully reignited on the first, second or third attempt, the Flame iQ resets itself (and will attempt 3 reignitions if the probe again senses a ‘flame out’).

The Flame iQ requires a power source (either 12 V or 240 V) to power the built-in electronics. The electronics power the lights on the control panel, the electronic solenoid to open and close off the gas supply, and the reignition sequence functionality. You cannot operate a Flame iQ without a power source.

The Flame iQ to suit Baby Q (Latest 3rd Generation) has been specifically designed for use on Weber Baby Q (Q1000N / Q1200N 3rd Generation).

If you have a Weber Baby Q Classic 1st or 2nd Generation, check out the Flame iQ to suit Baby Q (Classic 2nd Generation).

It cannot be retrofitted to other barbecues (Weber or other brand).

No, the Flame iQ does not impact the flow of gas to your barbecue, and does not impact the performance of your barbecue. If you are concerned about the performance of your barbecue, refer to the troubleshooting information in your Owner's Guide or reach out to our Customer Service team on 1300 301 290 if you require further information.

No, the Flame iQ does not require installation by a plumber or gas fitter. The Flame iQ comes with clear instructions for installation, usage and how to conduct a gas leak test post installation. If you require any further assistance, please reach out to our Customer Service team on 0800 493 237.

If you are connecting your Weber Baby Q with Flame iQ fitted to the plumbed LP connection of a caravan of boat, or to any other LP plumbed gas supply, you'll need to purchase a bayonet hose. If you are using your Weber Baby Q with Flame iQ fitted to an LP gas cylinder, you can use the hose supplied with the barbecue.