Customer Service 1-800-446-1071

How do I install the Weber iGrill 3 on my Genesis II?

To install your iGrill 3 on your Weber® Genesis® II grill, please follow these steps:
  1. Remove ‘iGrill 3 ready’ plate
  2. Ensure tank scale has one magnet installed
  3. Install bracket underneath side table
  4. Insert 3 AA batteries into the battery pack. Do not mix old and fresh batteries. Do not mix alkaline, standard, or rechargeable batteries.
  5. Set up the battery cable connection
  6. Connect the LP fuel level sensor connection which snaps into place. No screws are required
  7. Before applying wire clip, clean the surface. Peel and stick the wire clip, ensuring that all wires are secured using the wire retention clip
  8. Download the Weber iGrill App, press and release the power button, and launch app and connect through Bluetooth

Please reference your Installation Guide for a visual representation of these instructions.

If you have any further questions, please contact our iGrill team at support@weberstephen.com

Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG Inc.

Was this FAQ helpful?

Search FAQs

see all FAQs